The image is from Wikipedia Commons
RF power amplifier
A radio frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency signal into a higher power signal. Typically, RF power amplifiers drive the antenna of a transmitter. Design goals often include gain, power output, bandwidth, power efficiency, linearity (low signal compression at rated output), input and output impedance matching, and heat dissipation.
Many modern RF amplifiers operate in different modes, called “classes”, to help achieve different design goals. Some classes are class A, class AB, class B, class C, which are considered the linear amplifier classes. In these classes the active device is used as a controlled current source. The bias at the input determines the class of the amplifier. A common trade-off in power amplifier design is the trade-off between efficiency and linearity. The previously named classes become more efficient, but less linear in the order they are listed. Operating the active device as a switch results in higher efficiency, theoretically up to 100%, but lower linearity. Among the switch-mode classes are Class D, Class F and class E. The Class D amplifier is not often used in RF applications, because the finite switching speed of the active devices and possible charge storage in saturation could lead to a large I-V product, which deteriorates efficiency.
Solid state vs. vacuum tube amplifiers
Modern RF power amplifiers use solid-state devices such as bipolar junction transistors and MOSFETs. Transistors and other modern solid-state devices have replaced vacuum tubes in most electronic devices, but tubes are still used in some high-power transmitters (see Valve RF amplifier). Although mechanically robust, transistors are electrically fragile – they are easilly damaged by excess voltage or current. Tubes are mechanically fragile, but electrically robust – they can handle remarkably high electrical overloads without appreciable damage.
The basic applications of the RF power amplifier include driving to another high power source, driving a transmitting antenna and exciting microwave cavity resonators. Among these applications, driving transmitter antennas is most well known. The transmitter–receivers are used not only for voice and data communication but also for weather sensing (in the form of a radar).
Wideband amplifier design
is defined as the breakdown voltage
is defined as the knee voltage
and is being chosen so the rated power can be met. The external load is typically , therefore there must be some sort of transformation that transforms from to .
The loadline method is often used in RF power amplifier design.
- Lee, Thomas (2003). The Design of CMOS Radio-Frequency Integrated Circuits. Cambridge: Cambridge University Press. pp. 494–503.
- Cloutier, Stephen R. "Class E AM Transmitter Descriptions, Circuits, Etc". www.classeradio.com. WA1QIX. Retrieved 6 June 2015.
- MFJ Enterprises. "Ameritron ALS-1300 1200-watt NO TUNE TMOS-FET AMPLIFIER". MFJ Enterprises. Retrieved 6 June 2015.
- Matthew Ozalas (January 14, 2015). "How to Design an RF Power Amplifier: The Basics". youtube.com. Retrieved 2015-02-10.
- Carlos Fuentes (October 2008). "Microwave Power Amplifier Fundamentals" (PDF). Retrieved 2013-03-05.
- Khanifar, Ahmad. "RF Power Amplifier Design for Digital Predistortion". www.linamptech.com. Retrieved 1 December 2014.
- This page is based on the Wikipedia article RF power amplifier; it is used under the Creative Commons Attribution-ShareAlike 3.0 Unported License (CC-BY-SA). You may redistribute it, verbatim or modified, providing that you comply with the terms of the CC-BY-SA.