Rotax 912

Rotax 912
3Xtrim3X55TrainerC-IFUF46Rotax912Sinstallation.jpg
Rotax 912ULS 100 hp (75 kW) installation in a 3Xtrim 3X55 Trener
Type Piston aircraft engine
National origin Austria
Manufacturer Rotax Aircraft Engines
First run 1984
Major applications Light sport aircraft
Ultralight aircraft
Produced 1989–present
Variants Rotax 914
Rotax 915 iS
Rotax 912ULS 100 hp (75 kW) installation in a Blue Yonder Merlin EZ
Pusher engine installation of two Rotax 912ULSs in a Lockwood Aircam
Rotax 912ULS with tuned exhaust in a Dyn'Aéro MCR01 with 3-blade hydraulic CSU propeller.

The Rotax 912 is a naturally aspirated, air- and water-cooled, horizontally opposed four-cylinder, four-stroke, gear reduction-drive engine commonly used on certified aircraft, light sport aircraft, ultralight aircraft and unmanned aerial vehicles. Rotax produced its 50,000th 912-series engine in 2014.[1]

Design and development

The Rotax 912 was first sold in 1989 in non-certificated form for use in ultralights and motorgliders.[2] The original 80 hp (60 kW) 912 UL engine has a capacity of 1,211 cc (73.9 cu in) and a compression ratio of 9.1:1.

The engine differs from conventional aircraft engines (such as the Lycoming O-235) in that it has air-cooled cylinders with liquid-cooled heads[3] and uses a 2.43:1 gearbox (PSRU) to reduce the engine's relatively high 5,800 rpm shaft speed to a more conventional 2,400 rpm for the propeller. The gearbox has proven to be generally trouble-free.[2] On the 912A, F and UL the standard reduction ratio is 2.27:1 with 2.43:1 optional. Lubrication is dry sump, and fuelling is via dual CV carburetors or fully redundant electronic fuel injection. The electronic fuel injected Rotax 912iS is a recent development.[3]

The 912 oiling system differs from most dry-sump designs in that lubricating oil is forced into the storage tank by crankcase pressure rather than by a separate scavenge pump. This requires a novel preflight inspection procedure: before checking the oil level with the dipstick, the engine is "burped" by removing the oil filler cap and turning the propeller until a gurgling sound is heard, which indicates that all oil has been forced into the tank and the oil level can now be checked accurately.[2]

The 912 is more fuel efficient and lighter than similarly sized traditional engines, e.g., Continental O-200, but originally had a shorter time between overhaul (TBO). On introduction, the TBO was only 600 hours, which was double that of previous Rotax engines but far short of existing engines of comparable size and power. The short TBO and lack of certification for use in factory-built type certificated aircraft initially restricted its worldwide market potential. However, the engine received US Federal Aviation Administration (FAA) certification in 1994, and by 1999, the TBO had increased to 1,200 hours;[2] on 14 December 2009, the TBO was raised from 1,200 hours to 1,500 hours, or 1,500 hours to 2,000 hours, depending on serial number.[4] In addition to the lower fuel consumption, the 912 is certified to run on automotive fuel (mogas), further reducing running costs, especially in areas where leaded avgas is not readily available.[3] The 912 may be operated using leaded fuel, but lead sludge will accummulate in the oil tank and reduction gearbox, and the fuel is incompatible with the recommended synthetic oil because it cannot hold lead in suspension; consequently, using leaded fuel mandates additional maintenance, and unleaded fuel is recommended.[2]

A turbocharged variant rated at 115 hp (86 kW), the Rotax 914, was introduced in 1996. In 1999, the 912S / ULS were introduced;[2] enlarged to 1,352 cubic centimetres (82.5 cu in) with a compression ratio of 10.8:1, yielding 100 hp (75 kW). The 912S is certified, as are the A and F, which are used in the Diamond DA20, which is quite popular in Europe. The 912's popularity was greatly enhanced by the introduction of the light-sport aircraft category in Europe and the United States, which resulted in the introduction of many factory-built aircraft designed to fully exploit the engine's small size and light weight.[2] The 100 hp (75 kW) versions are used in many light sport aircraft, such as the Zenith STOL CH 701 and the Tecnam P2002 Sierra. The 80 hp (60 kW) versions are sufficient to power the new generation of efficient motorgliders, such as the Pipistrel Sinus and the Urban Air Lambada. It is also fitted to some light twins, such as the Tecnam P2006T.

On 8 March 2012 the company displayed its 912 iS variant, a 100 hp (75 kW) version with fuel injection and an electronic engine management unit.[5] The version weighs 63 kg (139 lb), which is 6 kg (13 lb) more than the standard 912S. The non-certified 912 iS targets the Light Sport and Experimental market and 912 iSc will be certified. Production started in March 2012 and the engine has a 2000-hour recommended time-between-overhaul to start.[6]

On 1 April 2014 the company announced its new 912 iS Sport upgrade with greater power and torque and reduced fuel consumption.[7] A further derivative, the 135 hp (101 kW) Rotax 915 iS, was announced in July 2015.[8]

Warnings

Unlike most other manufacturers of similar engines, Rotax provides extensive warnings in the owner's manual, about both the certified and non-certified versions of the engine design, warning pilots that the engine is not suitable for use in situations where a safe landing cannot be made, for use in rotorcraft, for night flying (unless equipped with redundant electrical power), or for aerobatics. It furthermore states that the company gives no assurances that the engine is suitable for use in any aircraft, that the "engine may seize or stall at any time. This could lead to a crash landing and possible severe injury or death" and that "non-compliance [with the warnings provided] can result in serious injuries or death!"[9]

Variants

The engine is available in the following versions:

912 A#
Certified to JAR 22, 80 hp (60 kW), with dual carburetors and electronic ignition
912 F#
Certified to FAR 33, 80 hp (60 kW), with dual carburetors and electronic ignition
912 iS
Uncertified, 100 hp (75 kW) with direct fuel injection and an electronic engine management unit [6]
912 iSc
Certified, 100 hp (75 kW) with direct fuel injection and an electronic engine management unit [6]
912 iS Sport
Uncertified, aluminum airbox, longer intake runners and eco-mode when operated below 97% power setting. [10] [11]
912 S#
Certified to FAR 33, 100 hp (75 kW) with larger bore than 912A/F/UL, with dual carburetors and electronic ignition
912 UL#
Uncertified, 80 hp (60 kW), similar to the 912A/F
912 ULS#
Uncertified, 100 hp (75 kW), similar to the 912S
912 ULSFR#
Uncertified French Authority specification. 100 hp (75 kW)

The # in the designation stands for:

  1. Shaft with flange for fixed pitch propeller, P.C.D. 100 mm
  2. Shaft with flange for fixed pitch propeller, P.C.D. 75 mm, P.C.D. 80 mm and P.C.D. 4 inches
  3. Shaft with flange for constant speed propeller P.C.D. 75 mm, P.C.D. 80 mm, P.C.D. 4 inches and drive for hydraulic governor for constant speed propeller
  4. Shaft with flange for fixed speed propeller P.C.D. 75 mm, P.C.D. 80 mm, P.C.D. 4 inches also can be fitted with an adaptor, drive and governor for a constant speed propeller.

Applications

Specifications (Rotax 912 UL/A/F)

General characteristics

  • Type: four-cylinder, four-stroke liquid / air-cooled engine with opposed cylinders, dry sump forced lubrication with separate oil tank, automatic adjustment by hydraulic valve tappet, dual CD carburetors, mechanical diaphragm pump, electronic dual ignition, electric starter, integrated reduction gear 1 : 2.273 or 1 : 2.43
  • Bore: 79.5 mm (3.13 in)
  • Stroke: 61 mm (2.40 in)
  • Displacement: 1,211.2 cm3 (73.91 in3)
  • Length: 561 mm (22.1 in)
  • Width: 576 mm (22.7 in)
  • Dry weight: 60 kg (132.3 lb) with electric starter, carburetors, fuel pump, air filters and oil system

Components

  • Valvetrain: OHV, hydraulic lifters, pushrods, rocker arms
  • Fuel type: Unleaded: 87 octane AKI (Canada/USA) / 90 octane RON (European) or higher. Leaded fuel and AVGAS 100 LL can be used but are not recommended.
  • Oil system: Dry sump with trochoid pump, camshaft driven
  • Cooling system: Liquid-cooled cylinder heads, air-cooled cylinders

Performance

See also

Comparable engines

Related lists

References

  1. ^ "Rotax Rolls Out 50,000 912-Series Engine". 2014-06-06. Retrieved 7 June 2014.
  2. ^ a b c d e f g Busch, Mike (1 June 2017). "Opinion: Savvy Maintenance - Outside the Box: The Rotax 912 is Delightfully Different". AOPA Pilot. Aircraft Owners and Pilots Association. Retrieved 10 April 2020.
  3. ^ a b c Rotax (September 2012). "Operators Manual for Rotax engine type 912 series" (PDF). Retrieved 21 June 2015.
  4. ^ Rotax (December 2009). "Extension of Time Between Overhauls (TBO) for Rotax Engine Type 912 and 914 (Series)" (PDF). Retrieved 2010-02-11.
  5. ^ "Rotax Introduces 921iS". Sport Aviation: 14. May 2012.
  6. ^ a b c Bertorelli, Paul (8 March 2012). "BRP/Rotax Rolls Out New Engine". AVweb. Retrieved 14 March 2012.
  7. ^ "Rotax lowers fuel burn, boosts performance with 912 iS Sport". aopa.org. April 2014. Retrieved 22 July 2015.
  8. ^ "Rotax-Owner.com - ROTAX 915 IS: BRP UNVEILS A NEW TURBOCHARGED ROTAX AIRCRAFT ENGINE". rotax-owner.com. Retrieved 22 July 2015.
  9. ^ BRP-Rotax (1 September 2012). "Operators Manual Rotax Type 912 Series" (PDF). Archived from the original (PDF) on 30 June 2014. Retrieved 5 August 2014.
  10. ^ Sport Aviation: 14. May 2014. Missing or empty |title= (help)
  11. ^ "Rotax 912 iS: Better than predicted". generalaviationnews.com. 27 June 2013. Retrieved 10 August 2016.

External links

Copyright